OSI/MHS Configuration and Management Manual

OSI/MHS Configuration and Management Manual—424827-003
A-1
A
Examples of Configuration Files
This appendix contains the files required to install and configure each OSI/MHS MTA
described in Section 5, Configuring Your OSI/MHS Subsystem. It also contains the
SCF command files that configure OSI/AS and OSI/TS to support each MTA, and an
overview of these configurations. It includes the following:
•
MTA1
•
Installation file for MTA1
•
OSI/MHS configuration command file for MTA1
•
Overview of the OSI configuration for MTA1
•
OSI/AS and OSI/TS configuration command file for MTA1
•
MTA2
•
Installation file for MTA2
•
OSI/MHS configuration command file for MTA2
•
Overview of the OSI configuration for MTA2
•
OSI/AS and OSI/TS configuration command file for MTA2
•
MTA3
•
Installation file for MTA3
•
OSI/MHS configuration command file for MTA3
•
Overview of the OSI configuration for MTA3
•
OSI/AS and OSI/TS configuration command file for MTA3
The source files for these examples are included in the OSI/MHS software. They
reside in the ISV subvolume ZOSIMHS.
For an example that configures OSI/AS, OSI/TS, and OSI/MHS to use a TCP/IP
connection to the Internet, see the OSI/AS and OSI/TS Supplement (Includes RFC-
1006 Support).
Note. In some cases, the example files reprinted in this appendix use lowercase characters for
readability. Remember that SCF shifts string values to uppercase unless you enclose them in
quotes
(" "). Thus, the surnames, given names, and passwords in the example configuration
are defined internally as uppercase strings.