OSI/MHS Management Programming Manual

About This Manual
OSI/MHS Management Programming Manual—424824-001
xix
The OSI/MHS Manual Set
•
OSI/MHS Gateway Programmatic Interface (GPI) Programming Guide contains
information to teach TAL and C programmers how to use the Compaq OSI/MHS
GPI product effectively.
•
OSI/MHS Gateway Programmatic Interface (GPI) Reference Manual contains
reference information for TAL and C programmers using the GPI library procedures.
•
OSI/MHS P7 Application Programmatic Interface (P7 API) Manual contains
programming and reference information for C programmers who use the P7 API
procedures.
•
OSI/MHS Configuration and Management Manual describes how to plan, install,
configure, manage, and maintain a Compaq OSI/MHS subsystem.
•
OSI/MHS Administrative Utility (AU) Manual describes how to install, configure,
and use the AU, a Compaq utility that allows users to obtain information about
messages, reports, or probes (communications sent by an originator to the message
transfer system (MTS) to test delivery of a message or report) in the form of
Protocol Data Units (PDUs).
•
Operator Messages Manual describes system messages and provides an explanation
of the cause, a discussion of the effect on the system, and suggestions for corrective
action.
•
OSI/MHS SCF Reference Manual describes the SCF commands used to configure
and manage the OSI/MHS subsystem. These commands are the interactive
equivalents of the programmatic commands described in this manual.