OSI/MHS Management Programming Manual

Commands and Responses
OSI/MHS Management Programming Manual—424824-001
5-262
STATUS MON
ZSPI-TKN-ALLOW-TYPE
ZSPI-TKN-RESPONSE-TYPE,
ZSPI-TKN-COMMENT
are described in the SPI Programming Manual.
ZCOM-TKN-SEL-SUMSTATE
is described in the SPI Common Extensions Manual.
Tokens in Response Buffer
ZSPI-TKN-DATALIST
introduces a data list, as described in the SPI Programming Manual; the final
ZSPI-TKN-ENDLIST ends the data list. These tokens enclose the other response
tokens only if the value of the header token ZSPI-TKN-MAXRESP is not 0.
ZCOM-TKN-OBJTYPE
ZCOM-TKN-OBJNAME
ZCOM-TKN-OBJSTATE
are described in the SPI Common Extensions Manual.
ZCOM-TKN-BKUP-STATE
is the current state of the backup. This token is required. The possible values are:
ZCOM-VAL-SUMSTATE-STOPPED
No backup is running. The backup can be run by altering the backup CPU with
the ALTER command.
ZCOM-VAL-SUMSTATE-STARTING
The backup has been initiated but is not yet running.
ZCOM-VAL-SUMSTATE-STARTED
The backup is running and can receive takeovers.
ZCOM-VAL-SUMSTATE-STOPPING
The backup is being stopped.
ZCOM-TKN-TKOVR-CNT
is the number of times an unplanned takeover has occurred. This token is required.
The count is reduced automatically once every five minutes.