OSI/MHS Management Programming Manual
Password Server Interfaces
OSI/MHS Management Programming Manual—424824-001
7-57
MPS Error and Informational Messages
Effect. The MPS attempts to continue, unless this warning occurs in connection with 
other errors that cause it to ABEND. A database inconsistency might exist in this case.
Recovery. Review the file-system error number, and attempt to determine the reason 
for failure. Verify the correct installation and operation of TMF on your NonStop 
system.
Cause. This message reports an inconsistency between a request from OSI/MHS and 
the MPS's own database information.  The specific inconsistency is stated in the 
message text.
Effect. The MPS proceeds with normal operation.
Recovery. Stop the MPS concerned and all the APPLs that are served by that MPS. 
Use the SCF INFO APPL command to verify the configuration of the APPL(s) in 
OSI/MHS. If the configuration is incorrect, correct it using SCF. Then follow the 
procedures for adding APPLs to the authorization database from an OSI/MHS 
subsystem with APPLs already defined.
Cause. This message reports an inconsistency between a request from OSI/MHS and 
the MPS's own database information.  The specific inconsistency is stated in the 
message text.
Effect. The MPS does not update the authorization database.
Recovery. Stop the MPS concerned and all the APPLs that are served by that MPS. 
Use the SCF INFO APPL command to verify the configuration of the APPL(s) in 
OSI/MHS. If the configuration is incorrect, correct it using SCF. Then follow the 
procedures for adding APPLs to the authorization database from an OSI/MHS 
subsystem with APPLs already defined.
Cause. This message reports a possible security threat against the OSI/MHS subsystem 
served by the MPS, specifically an attempt by an unauthorized process to open the MPS.
Effect. The MPS does not accept requests from the opener but continues to serve all 
other openers normally.
Recovery. Attempt to locate the source of the security threat and remove it. If 
necessary, change the code of the MPS to report the process ID of the process that is the 
source of the messages.
*** warning *** APPL <value> has already been added to
 database
*** warning *** APPL <value> has not yet been added to
 database
*** warning *** Attempt to OPEN MPS by a process that is not
 owned by the same owner as the MPS was
 rejected










