OSI/MHS Management Programming Manual

Common Definitions
OSI/MHS Management Programming Manual—424824-001
4-19
Accounting Tokens
ZMHS-TKN-ASSOC-CHK-PNT-SZ (ZSPI-TYP-INT)
shows the negotiated checkpoint size for RTS association.
ZMHS-TKN-ASSOC-DIR (ZSPI-TYP-ENUM)
specifies the association direction according to the following values:
ZMHS-TKN-ASSOC-END-RSN (ZSPI-TYP-ENUM)
specifies the reason for end of association according to the following values:
ZMHS-TKN-ASSOC-END-TIME (ZSPI-TYP-TIMESTAMP)
indicates the time the association ended.
ZMHS-TKN-ASSOC-ID (ZSPI-TYP-INT2)
specifies the local association identifier. Each individual MHS Process that handles
associations allocates an association identifier, starting from 0 and incrementing for
each additional association established. As associations end, their association IDs
may be reused. Thus, association IDs are only unique among all concurrent
associations within a single process. If a process shuts down or fails, then restarts,
associations may be recovered. In this case, the association identifier may be
different from the one prior to the shutdown or failure.
ZMHS-TKN-ASSOC-REJECT (ZSPI-TYP-ENUM)
specifies the reason for failure to open an association. The possible values are:
ZMHS-VAL-ASSOC-DIR- Value Meaning
IN 0 Incoming associations
OUT 1 Outgoing associations
ZMHS-VAL-ASSOC-END-RSN- Value Meaning
NORMAL 0 Normal closure
ABORT 1 Association abort
ZMHS-VAL-ASSOC-REJECT- Value Meaning
RTS-BUSY 0 RTS busy
RECOVER 1 Cannot recover
VALIDATE 2 Validation failure
BAD-MODE 3 Unacceptable dialog mode
MTA-BUSY 4 MTA busy
UNKNOWN 5 Unknown calling session address
BAD-TURN 6 Unacceptable turn