OSI/MHS SCF Reference Manual

OSI/MHS SCF Commands

OSI /MHS SCF Reference Manual—424828-001

2-97

ALTER MTA Command

The ALTER MTA command changes the configuration of an adjacent MTA. This is a

sensitive command.

OUT file-spec

directs any SCF output generated for this command to the specified file.

[\psystem.]$proc.#mta

is the name of the MTA object to be altered.

attribute-spec

is a specification of an attribute and a value to be assigned to it. The attribute-

spec for the ALTER MTA command is identical to that of the ADD MTA

command listed earlier in this section with the exceptions listed in “Considerations”

below:

Considerations

•

The MTA must be in the STOPPED state before attributes can be altered.

•

ISO-COUNTRY-NAME, REM-ADMD, REM-MTA-NAME, and REM-PRMD

cannot be altered.

•

All of the attributes are optional with this exception: if REM-LOGON-

VALIDATION is ON, then you must specify REM-OUR-PASSW and REM-

THEIR-PASSW.

•

You can specify pairs of OSI addresses or elements within OSI addresses as not in

use by specifying the address name with no accompanying value.

•

See the ADD MTA command “Considerations” for the restrictions on legal

combinations of attributes; these restrictions also apply to the ALTER MTA

command.

Example

This command alters an MTA attribute:

ALTER MTA $ZMHS.#NEWYORK, REM-NSAP-1 470010060210

ALTER [ / OUT file-spec / ] MTA [\psystem.]$proc.#mta

[ , attribute-spec ]...