OSI/MHS SCF Reference Manual

OSI/MHS SCF Commands
OSI /MHS SCF Reference Manual—424828-001
2-127
NAMES Command Displays
See the command syntax summary in Appendix A, OSI/MHS SCF Command
Syntax Summary, to see where SUB is supported for this command.
SEL [ NOT ] state
directs the command only at objects in the specified state or not in the specified
state. Valid values for state are: DEFINED, STARTING, STARTED,
STOPPING, STOPPED, and SUSPENDED. States are described in Section 1,
Introduction.
Example
NAMES displays the names of all the objects defined in the OSI/MHS subsystem:
NAMES $ZMHS
NAMES Command Displays
The information displays that result from entry of a NAMES command for each of the
object types listed above are shown on the following pages.
NAMES APPL Display
The format of the display for the NAMES APPL command is:
APPL
is a list of APPL object names.
An example of the display for the NAMES APPL command is:
MHS Names APPL appl-name
APPL
appl-name
MHS Names APPL \POPI.*
APPL
UAGW11 UAGW12 UAGW13 UAGW14 UAGW15 UAGW16 UAGW17 UAGW1D10
UAGW1D11 UAGW1D12 UAGW1D13 UAGW1D14 UAGW1D15 UAGW1D16 UAGW1D17 UAGW1D18
UAGW1D19 UAGW1D20 UAGW1D21 UAGW1D30 UAGW1D31 UAGW1D40 UAGW1D41 UAGWA21
UAGWA22 UAGWA31 UAGWA32 UAMS11 UAMS12 UAMS13 UAMS14 UAMS15
UAMS16 UAMS17 UAMS18 UAMS1D10 UAMS1D11 UAMS1D12 UAMS1D13 UAMS1D14
UAMS1DUP