OSI/MHS SCF Reference Manual

OSI/MHS SCF Error Messages
OSI /MHS SCF Reference Manual—424828-001
B-3
MHS E00010
Cause. The following situations can cause this error:
•
In a command used to add or alter an MTA, an OSI address was specified that is
used by another MTA.
•
In a command used to add or alter a group, an OSI address was specified that is used
by a group of a different type.
Recovery. Retry the command, using a different OSI address.
MHS E00011
Cause. In a command used to add or alter an object, a node was specified that is not
that of the MHSMGR process.
Recovery. Retry the command, using the MHS manager’s node.
MHS E00012
Cause. The following situations can cause this error:
•
In a command used to add or alter an APPL, DLIST, or ROUTE object, an O/R
name was specified that was the same as one already configured.
•
A CUGMEMBER was specified using an O/R name that was the same as another
CUGMEMBER within the same CUG.
Recovery. Retry the command, using a different O/R name.
MHS E00013
Cause. An attempt was made either to add an MS APPL object using an access name
that did not match an existing MS GROUP or to add a gateway APPL object using an
access name that did not match an existing GATEWAY object.
Recovery. Retry the command, using a valid ACCESS-NAME.
MHS E00010 Duplicate OSI address: OSI-address
MHS E00011 System name must be same as OSI/MHS manager's
MHS E00012 Duplicate O/R name for object-name
MHS E00013 Invalid ACCESS-NAME specified for object-name