OSI/MHS SCF Reference Manual

OSI/MHS SCF Error Messages
OSI /MHS SCF Reference Manual—424828-001
B-6
Recovery. Ask the user agent to remove the appropriate attribute from its list-and-fetch-
attribute default set (using the X.400 P7 operation “register-ms”), or set the SET-RTVL-
DEFAULTS attribute to ON using the ALTER command.
MHS E00023
Cause. An attempt was made to use the TRACE PROCESS command when the
GROUP object to which the process belongs was in a STARTING state.
Recovery. Retry the command when the GROUP object is in a STARTED state.
MHS E00024
Cause. The O/R name specified has resulted in a non-unique key in the routing
database and exceeds a non-unique key internal limit. This error typically occurs when
the configuration contains a large number of O/R names that are distinguished only by
low-level name components.
Recovery. Retry the command using an O/R name in which a distinction is made at a
higher level, or use hierarchical routing and generic APPLs.
MHS E00025
Cause. The MR group specified in a DELETE command is configured to be used by
MS groups for message submission.
Recovery. Delete the MS group objects or reassign them to other MR groups, then retry
the command.
MHS E00026
Cause. When adding or altering an APPL or ROUTE object, both the X.121 address
and the numeric user identifier were partially or fully wild-carded. Only one of these
two O/R name attributes can be wild-carded.
Recovery. Retry the command, partially specifying only one attribute. If the partially
specified command already exists, remove it by repeating the command and entering an
asterisk (*) against the attribute.
MHS E00023 Command cannot be performed on process whose group
is in summary-state state for object-name
MHS E00024 Non-unique O/R name specified for object-name
MHS E00025 Cannot delete object-name - MS groups attached
MHS E00026 More than one wildcarded O/R name attribute
specified