OSI/MHS SCF Reference Manual

OSI/MHS SCF Error Messages
OSI /MHS SCF Reference Manual—424828-001
B-7
MHS E00027
Cause. When adding or altering an APPL or ROUTE object, either the X.121 address or
the numeric user identifier contained invalid characters. Check for one of the following
conditions:
•
Characters other than 0 through 9 and asterisk (*) in the string
•
An asterisk that is not at the end of the string
•
More than one asterisk in the string
Recovery. Retry the command, specifying valid characters.
MHS E00028
Cause. Adding or altering an APPL or ROUTE object caused the maximum count of
partially specified OR addresses to be exceeded.
Recovery. Remove other unused partially specified OR addresses and retry the
command.
MHS E00029
Cause. An attempt to start an MS group failed because there are no MR groups
configured for that MS group.
Recovery. Alter the MS group so that it has MR groups configured for message
submission. If necessary, add the MR groups.
MHS E00030
Cause. An attempt has been made to configure a nonexistent gateway as the
downgrade-gateway.
Recovery. Add the gateway first and then re-enter the command or configure an
existing gateway for downgrading.
MHS E00201
Cause. An invalid case value was generated with no associated case label.
MHS E00027 Invalid wildcarded O/R name attribute entered
MHS E00028 Too many wildcarded OR names have been entered
MHS E00029 Cannot start MS group - no MR groups configured
MHS E00030 INTERNAL ERR: Non-existent gateway configured for
P22 downgrading
MHS E00201 INTERNAL ERR: Case value out of range