OSI/MHS SCF Reference Manual

OSI/MHS SCF Error Messages
OSI /MHS SCF Reference Manual—424828-001
B-11
•
When specifying the ACCESS-TYPE attribute as GW, the ACCESS-NAME must
be specified as [\gsystem.]gateway-name.
MHS E00220
Cause. An invalid node name has been specified.
Recovery. Retry the command specifying the MHS manager’s node name.
MHS E00221
Cause. The REM-LOGON-VALIDATION attribute was selected and given a value of
OFF or was not specified. When this situation exists, neither the REM-THEIR-PASSW
nor the REM-THEIR-PASSW-RSP attributes can be entered.
Recovery. Retry the command without specifying the REM-THEIR-PASSW or REM-
THEIR-PASSW-RSP attributes, or specify the REM-LOGON-VALIDATION attribute
using the value ON.
MHS E00222
Cause. The REM-LOGON-VALIDATION attribute was selected and given a value of
ON. When this situation exists, the REM-THEIR-PASSW attribute must be entered.
Recovery. Retry the command providing the REM-THEIR-PASSW attribute.
MHS E00223
Cause. For an OSI address to be accepted, at least the local and remote NSAP must be
specified. At least one OSI address must be specified on an ADD command. One of
these conditions is incorrect on the command line.
Recovery. Reenter the command correctly specifying the OS I address.
MHS E00224
Cause. The following conditions can cause this error:
MHS E00220 Invalid node name
MHS E00221 Cannot enter REM-THEIR-PASSW or REM-THEIR-PASSW-RSP
unless REM-LOGON-VALIDATION is specified as ON
MHS E00222 Must enter REM-THEIR-PASSW when
REM-LOGON-VALIDATION is ON
MHS E00223 A non-existent or incorrectly specified
OSI address was entered
MHS E00224 Illegal combination of MTA password attributes