OSI/MHS SCF Reference Manual

OSI/MHS SCF Commands

OSI /MHS SCF Reference Manual—424828-001

2-28

ADD CLASS Command

The ADD CLASS command configures information that is specific to a group class.

This is a sensitive command.

OUT file-spec

directs any SCF output generated for this command to the specified file.

[\psystem.]$proc.#class

specifies the name of the CLASS object to be added.

attribute-spec

is a specification of an attribute and a value to be assigned to it. The attributes and

their values are listed below. All attributes for this command are listed first,

followed by all descriptions.

The attribute-spec for the ADD CLASS command when the access type is MR is

one of the following attribute name and value combinations:

ADD [ / OUT file-spec / ] CLASS [\psystem.]$proc.#class

[ , attribute-spec ]...

[ ASSOC-CLOSE-TIME time ]

[ ASSOC-OPEN-TIME time ]

[ CHECK-POINT-SIZE integer ]

[ CLEANER-INTERVAL time ]

[ CLEANER-TIME hour:minute ]

[ CLOSE-TIME time ]

[ CUG-CHECK { NONE | ALL } ]

[ DELAY-TIME time ]

[ LINK-RETRY-DELAY time ]

[ LINK-RETRY-TIME time ]

[ MAX-MSG-XFER-TIME time ]

[ NONURGENT-COUNT integer ]

[ NONURGENT-ROUTE-RETRY-DELAY time ]

[ NONURGENT-ROUTE-RETRY-GROW integer ]

[ NONURGENT-ROUTE-RETRY-TIME time ]

[ NONURGENT-TIME time ]

[ NORMAL-COUNT integer ]

[ NORMAL-ROUTE-RETRY-DELAY time ]

[ NORMAL-ROUTE-RETRY-GROW integer ]

[ NORMAL-ROUTE-RETRY-TIME time ]

[ NORMAL-TIME time ]

[ OPEN-RETRY-TIME time ]

(continued)