OSI/MHS SCF Reference Manual

OSI/MHS SCF Commands

OSI /MHS SCF Reference Manual—424828-001

2-56

ADD GROUP Command

The ADD GROUP command defines a group of a given class to the OSI/MHS

subsystem. Several groups can be defined for each of the five classes—GI, LO, MR,

MS, and RS. These groups are referred to as the GI, LO, MR, MS, and RS groups. This

is a sensitive command.

OUT file-spec

directs any SCF output generated for this command to the specified file.

[\psystem.]$proc.#class.[\gsystem.]group

is the name of the GROUP object to be added.

attribute-spec

is a specification of an attribute and a value to be assigned to it. The attributes and

their values are listed below.

The attribute-spec for all classes of the ADD GROUP command is one of the

following attribute name and value combinations:

BACKUP

specifies the alternate CPU in which a process belonging to the group is to run, if the

primary CPU for the process is not available. No range checking is done; however,

the maximum value of cpu-number should not exceed the number of CPUs on

the target system minus one (for example, 0 to 7 on an eight-CPU system).

CPU

specifies the CPU in which the processes in the group are to run. No range checking

is done; however, the maximum value of cpu-number should not exceed the

number of CPUs on the target system minus one (for example, 0 to 7 on an eight-

CPU system).

ADD [ / OUT file-spec / ] GROUP

[\psystem.]$proc.#class.[\gsystem.]group

[ , attribute-spec ]...

BACKUP cpu-number

CPU cpu-number

PDU-LOG-FILE file-name

PDU-STORE file-name

PRI integer

WORK-SV subvolume