OSI/MHS SCF Reference Manual

OSI/MHS SCF Commands
OSI /MHS SCF Reference Manual—424828-001
2-58
ADD GROUP Command
GI-PNAME
specifies the name of the GI process within this group. mhs-proc-name must be
entered as $proc.#pname. The node name cannot be specified. The process
must reside on the same node as the MHS manager.
GI-PRI
specifies the execution priority at which the GI process runs. This attribute is
optional; if it is omitted, the default priority-level value for the group is assumed.
The additional attribute-spec for the ADD GROUP command when the class is
LO is one of the following attribute name and value combinations:
LO-BACKUP
specifies the backup CPU number in which the LO process runs. This attribute is
optional; if it is omitted, the default backup CPU number for the group is assumed.
No range checking is done; however, the maximum value of cpu-number should
not exceed the number of CPUs on the target system minus one (for example, 0 to 7
on an eight-CPU system).
LO-CPU
specifies the CPU number in which the LO process runs. This attribute is optional;
if it is omitted, the default CPU number for the group is assumed. No range
checking is done; however, the maximum value of cpu-number should not
exceed the number of CPUs on the target system minus one (for example, 0 to 7 on
an eight-CPU system).
LO-PNAME
specifies the name of the LO process within this group. mhs-proc-name must be
entered as $proc.#pname. The node name cannot be specified. The process
must reside on the same node as the MHS manager.
LO-PRI
specifies the execution priority at which the LO process runs. This attribute is
optional; if it is omitted, the default priority-level value for the group is assumed.
[ LO-BACKUP cpu-number ]
[ LO-CPU cpu-number ]
LO-PNAME mhs-proc-name
[ LO-PRI integer ]