OSI/TS Management Programming Manual

INFO SERVICE Command
Commands and Responses
5–94 056786 Tandem Computers Incorporated
a remainder of zero. This field is applicable only if the full IP subset is
enabled. The values range from 0 through 65535. If the threshold is set to 0,
events are never generated.
ZIP-DISCARD-ADDR-THLD
is the threshold value that the IP entity compares to the counter ZIP-
DISCARD-ADDR. An L3-THLD event is generated whenever the counter
value is nonzero and dividing the counter value by the threshold value leaves
a remainder of zero. This field is applicable only if the full IP subset is
enabled. The values range from 0 through 65535. If the threshold is set to 0,
events are never generated.
ZIP-DISCARD-LIFE-THLD
is the threshold value that the IP entity compares to the counter ZIP-
DISCARD-LIFE. An L3-THLD event is generated whenever the counter value
is nonzero and dividing the counter value by the threshold value leaves a
remainder of zero. This field is applicable only if the full IP subset is enabled.
The values range from 0 through 65535. If the threshold is set to 0, events are
never generated.
ZIP-DISCARD-UNSUP-THLD
is the threshold value that the IP entity compares to the counter ZIP-
DISCARD-UNSUP. An L3-THLD event is generated whenever the counter
value is nonzero and dividing the counter value by the threshold value leaves
a remainder of zero. This field is applicable only if the full IP subset is
enabled. The values range from 0 through 65535. If the threshold is set to 0,
events are never generated.
ZIP-DISCARD-REASM-THLD
is the threshold value that the IP entity compares to the counter ZIP-
DISCARD-REASM. An L3-THLD event is generated whenever the counter
value is nonzero and dividing the counter value by the threshold value leaves
a remainder of zero. This field is applicable only if the full IP subset is
enabled. The values range from 0 through 65535. If the threshold is set to 0,
events are never generated.
ZIP-X25-SNDCF
specifies whether the subnetwork conversion function (SNDCF) is to be used.
This attribute is used only for X.25 networks. If set to ZSPI-VAL-TRUE,
SNDCF is enabled; if set to ZSPI-VAL-FALSE, SNDCF is disabled. The default
value is ZSPI-VAL-FALSE.
ZX25DISCONN-DELAY
is the maximum amount of time TSP should wait on an idle (unused) X.25
network connection before issuing a network disconnect request. The number