OSI/TS Management Programming Manual

INFO SERVICE Command
Commands and Responses
5–100 056786 Tandem Computers Incorporated
Only nonzero values are transmitted in the CR-TPDU. This parameter is
applicable for protocol classes 1 and 3 only. Acceptable values range from 0 (0
seconds) through 18000 (180 seconds), with a default value of 9000 (90
seconds).
ZTWR-TIMEOUT
specifies the amount of time to wait for reassignment after network connection
failures. If the value is 0 seconds, no reassignment is performed. Only
nonzero values are transmitted in the CR-TPDU. This parameter is applicable
for protocol classes 1 and 3 only. Acceptable values range from 0 (0 seconds)
through 18000 (180 seconds).
ZCONN-TIMEOUT
is the maximum amount of time that the transport entity should wait for a
response to a CR-TPDU before releasing the connection. The waiting time is
expressed in hundredths of a second (0.01 seconds per increment). The values
range from 300 (3 seconds) through 18000 (180 seconds).
ZDISCONN-TIMEOUT
is the maximum amount of time that the transport entity should wait for a
response to a DR-TPDU before releasing the connection. The waiting time is
expressed in hundredths of a second (0.01 seconds per increment). The values
range from 300 (3 seconds) through 18000 (180 seconds).
ZINBOUND-CR-CONG-THLD
is the threshold value that the Transport Layer compares to the counter
ZINBOUND-CR-CONG. An L4-THLD event is generated whenever the
counter value is nonzero and dividing the counter value by the threshold
value leaves a remainder of zero. The values range from 0 through 65535. If
the threshold is set to 0, events are never generated.
ZINBOUND-CR-CONF-ERR-THLD
is the threshold value that the Transport Layer compares to the counter
ZINBOUND-CR-CONF-ERR. An L4-THLD event is generated whenever the
counter value is nonzero and dividing the counter value by the threshold
value leaves a remainder of zero. The values range from 0 through 65535. If
the threshold is set to 0, events are never generated.
ZOUTBOUND-CR-CONF-ERR-THLD
is the threshold value that the Transport Layer compares to the counter
OUTBOUND-CR-CONF-ERR. An L4-THLD event is generated whenever the
counter value is nonzero and dividing the counter value by the threshold
value leaves a remainder of zero. The values range from 0 through 65535. If
the threshold is set to 0, events are never generated.