OSI/TS Management Programming Manual

SUSPEND PROCESS Command
Commands and Responses
5–198 056786 Tandem Computers Incorporated
ZCOM-TKN-OBJNAME
is the name of the process to be suspended. This token is required, must occur
only once, and must be the same as the TSP process name specified in either ZSPI-
TKN-MANAGER or ZCOM-TKN-XMGR.
ZCOM-TKN-CMD-TIMEOUT
is described in the Communications Management Programming Manual. This token is
optional; duplicate occurrences are not allowed.
ZSPI-TKN-RESPONSE-TYPE, ZSPI-TKN-ALLOW-TYPE, and ZSPI-TKN-
COMMENT
are described in the Distributed Systems Management (DSM) Programming Manual.
These tokens are optional and, with the exception of ZSPI-TKN-COMMENT,
duplicate occurrences are not allowed.
Tokens in Response Buffer
ZSPI-TKN-DATALIST and the final ZSPI-TKN-ENDLIST
enclose a data list, as described in the Distributed Systems Management (DSM)
Programming Manual. These tokens enclose the other response tokens only if the
value of the header token ZSPI-TKN-MAXRESP is nonzero. No more than one
data list can appear in the response.
ZCOM-TKN-OBJTYPE
specifies the type of object named in ZCOM-TKN-OBJNAME. The token value is
ZCOM-OBJ-PROCESS.
ZCOM-TKN-OBJNAME
is the name of the process that was to be suspended.
ZSPI-TKN-RETCODE
indicates whether or not the command was successful. If the command failed, this
token supplies the reason for the failure. Its use is described further in the
Distributed Systems Management (DSM) Programming Manual.
ZSPI-TKN-ERRLIST and ZSPI-TKN-ENDLIST
enclose a standard SPI error list, as described in the Distributed Systems
Management (DSM) Programming Manual.
Operational Note
If an application is using a subdevice when the command is issued, the process is
placed in the suspending state. After all opens against the subdevice are closed, then
the subdevice will be placed in the SUSPENDED state.