OSI/TS Management Programming Manual

C-Series and D-Series Compatibility
Introduction
056786 Tandem Computers Incorporated 1–11
Figure 1-5. High PIN to Low PIN Communication Permitted in D-Series Systems
D-Series D-Series
C-Series
Network View From a D-Series High PIN Process ($PRO1)
$PRO1 $PRO3
$PRO2 $PRO4 $PRO5
Legend
High PIN
Low PIN
030
OSI/TS-Specific Compatibility Information
It is assumed, in this case, that the application, OSI/TS, and X25AM or TLAM are all
running on D-series systems in an Expand network. This combination allows you to
take full advantage of the D-series system software; all processes may run at either a
high PIN or a low PIN and the application may take advantage of the D-series
Guardian 90 procedure calls.
C30 OSI/TS Running in a
C-Series System
The C30 version of OSI/TS, running at a low PIN, can run in a C-series system (a
system running a C30 version or higher of Guardian 90).
General Compatibility Information
Within a C-series system or between two or more C-series systems in an Expand
network, only low PIN processes are permitted.
OSI/TS-Specific Compatibility Information
It is assumed, in this case, that the application, OSI/TS, and X25AM or TLAM are all
running on C30 (or higher) C-series systems in an Expand network and that the
application is not using the D-series Guardian 90 procedure calls.