OSI/TS Management Programming Manual

ADD SU Command
Commands and Responses
5–18 056786 Tandem Computers Incorporated
ZX25REMOTENET
specifies the addressing conventions to be used when building the called
address in the call request packet. Possible values are:
ZOS4-VAL-X25-NETID-DATAPAC
ZOS4-VAL-X25-NETID-TELENET
ZOS4-VAL-X25-NETID-TRANSPAC
ZOS4-VAL-X25-NETID-TYMNET
ZOS4-VAL-X25-NETID-PSS
ZOS4-VAL-X25-NETID-DATEXP
ZOS4-VAL-X25-NETID-UNINET
ZOS4-VAL-X25-NETID-DATANET
ZOS4-VAL-X25-NETID-DDXP
ZOS4-VAL-X25-NETID-X25NP
ZOS4-VAL-X25-NETID-X25UD
ZOS4-VAL-X25-NETID-X25XA
ZOS4-VAL-X25-NETID-X25SA
The default value of this field is equal to the NETID value of the applicable
X.25 line.
ZX25THRUPUT
specifies the throughput class limit for calls received (data transmission from
the called DTE) and the throughput class limit for calls initiated (data
transmission from the calling DTE). No default value is provided. If you do
not supply a value, the SYSGEN value of the X25AM line is used. The
SYSGEN default value of X25AM is 4 (for both integers).
375
4 150
5 300
6 600
7 1200
8 2400
9 4800
10 9600
11 19200
12 48000
Note that these values are based on the CCITT X.25 recommendations for 1980
and 1984.
ZLOC-TSEL
specifies the local transport service access point selector. It is a string of
hexadecimal digits (0 through 9 and A through F) up to 64 digits maximum.
OSI/TS uses this field to build the calling TSAP-ID field of the CR-TPDU. If
the contents of the the field is all blanks, the CR-TPDU will not contain the