OSI/TS Management Programming Manual

ADD SU Command
Commands and Responses
056786 Tandem Computers Incorporated 5–27
Table 5-4. OSI/TS Protocol Selection for X.25 Wide Area Networks
Protocol Choice/Attribute X.25 Network X.25 Network with SNDCF and Full IP
ZNSPDEV Specifies an X.25 line Specifies an X.25 line
ZCLASS 0-4 4
ZX25DESTADDR 1 Ignored for incoming calls
2 Required for outgoing calls
1 Ignored for incoming calls
2 Required for outgoing calls
ZIP-X25-SNDCF OFF ON
ZIP-NULL-LAYER Ignored Ignored
ZESIS-ENABLE Ignored Ignored
ZLOC-NSAP 1 Optional for 1984 X.25
2 Do not configure this attribute for 1980 X.25
Required for both 1984 and 1980 X.25
ZRMT-NSAP 1 Optional for incoming calls
2 Do not configure this attribute for 1980 X.25
1 Optional for incoming calls
2 Required for outgoing calls for both 1984
and 1980 X.25
ZLAN-LOC-SNPA Ignored Ignored
ZLAN-RMT-SNPA Ignored Ignored
Note If the network is 1984, set the #L3 SERVICE attribute IPX25SNDCF1980ADDR to OFF before starting the
TSP process.