OSI/TS Management Programming Manual

ADD SU Command
Commands and Responses
5–28 056786 Tandem Computers Incorporated
Table 5-5. OSI/TS Protocol Selection for Local Area Networks
Protocol Choice/
Attribute Full IP with ES-IS Full IP, no ES-IS Null IP
ZNSPDEV Specifies a TLAM line Specifies a TLAM line Specifies a TLAM line
ZCLASS 4 4 4
ZX25DESTADDR Ignored Ignored Ignored
ZIP-X25-SNDCF Ignored Ignored Ignored
ZIP-NULL-LAYER Ignored OFF ON
ZESIS-ENABLE ON OFF OFF
ZLOC-NSAP Required*** Required*** Required*
ZRMT-NSAP 1 Optional for incoming calls
2 Required for outgoing calls
1 Optional for incoming calls
2 Required for outgoing calls
1 Optional for incoming calls*
2 Required for outgoing calls*
ZLAN-LOC-SNPA Optional Optional Required*
ZLAN-RMT-SNPA 1 Optional for incoming calls
2 Optional for outgoing calls; should
be left unspecified**
1 Optional for incoming calls
2 Required for outgoing calls
1 Optional for incoming calls*
2 Required for outgoing calls*
Note * In this case, you must specify the local or remote NSAP value in the SNPA format
(“FEmacaddress”). For a full explanation of the SNPA value, see the descriptions of the SNPA
attributes.
** By not providing a value, you enable the ES-IS protocol to obtain the LAN remote SNPA dynamically.
*** These values are optional for the OSI/TS C30 release. They are required for earlier product
versions.