OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-71
CHECK SU Command
TAP: State
shows the state that the Session Layer of the TAPS process is in. This is the current
session protocol state as defined by the session standard. Refer to ISO 8327 for the
possible values. (It’s the same value displayed in the L5 Protocol State attribute in
the OSI/AS STATUS SU command.)
TSP: SU Name
shows the TSP SU that meets the specified selection criteria.
TSP: Last Error
shows the last file system error that occurred on the selected SU at the TSP level. If
there was no error, 0 will be displayed.
TSP: Error Source
shows the source of the last error that OSI/TS returned regarding the SU at the TSP
level. Possible values are "L4", "L3" or " ". The field is blank if the TSP: Last
Error field is 0.
TSP: State
shows the state that the TSP process is in. This is the same value displayed in the
“TC-State” field in the OSI/TS STATUS SU command.
NSP: SU Name
shows the name of the network I/O process subdevice created by TSP to convey
transport protocol data units (TPDUs). The name shows either a network I/O
process subdevice currently in use for an active transport connection or for receiving
a connection, or the name is the network I/O process subdevice last used by the TSP
to convey TPDUs over this subdevice.
NSP: Last Error
shows the last file system error that occurred on the selected SU at the NSP level. If
there was no error, 0 will be displayed.
NSP: Error Source
shows the source of the last error reported to OSI/TS on the selected SU at the NSP
level.
Value: TLAM | X25AM