OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-81
CHECK SU Command
AEQualifier
shows the application entity qualifier for the application entry name.
APTitle
shows the AP title for the application entry name.
PSEL
shows the presentation service selector for the application entry name.
SSEL
shows the session service selector for the application entry name.
TSEL
shows the transport service selector for the application entry name.
NSAP
shows the NSAP address for the application entry name.
OSI/TS Detailed Status SU display
descriptions for this display can be found in this manual under the STATUS
command.
X25AM Line Info display
descriptions for this display can be found in the SCF Reference Manual for X25AM.
TLAM Status Line display
descriptions for this display can be found in the SCF Reference Manual for TLAM.
If using PAM instead of TLAM, consult the PAM Configuration and Management
Manual.
About the OSI/AS STATUS SU display:
For token settings, the Data token information is displayed on the same line as the other
token information.
If the SU being queried issued the connect request, the responding address values will
not be shown until the connection has been established and the responding application
name will never be shown.
Application names are present only if the user specifies them. A connection could just
as easily be established with addresses alone.
If the SU being queried issued the attach request, the initiator’s application name will
never be shown.