OSI/TS SCF Reference Manual

OSI/TS SCF Reference Manual—424832-001

2-1

OSI/TS SCF Commands

This section contains the following information:

•

A table describing the Subsystem Control Facility (SCF) commands supported by

the OSI/TS subsystem and the object types supported for each command

•

Detailed information about object specification syntax

•

The following detailed information about each SCF command:

•

A description of the command function

•

The command syntax

•

The object specification, which shows the supported object types and object

names

•

Descriptions, by object type, of the attribute-specs, if any

•

Considerations to be aware of before using the command

•

Command examples

Supported Commands and Object Types

Table 2-1, OSI/TS Commands and Object Types lists the SCF commands supported by

the OSI/TS subsystem (through the TSP process) and the applicable object types.

This manual describes the SCF commands that are interpreted specifically for the

OSI/TS subsystem. Other commands that are generally supported by SCF, such as the

ASSUME and ENV commands, are not documented in this manual. See Appendix E,

OSI/TS Command Support for a list of all the SCF commands that can be issued to the

OSI/TS subsystem. The Subsystem Control Facility (SCF) Reference Manual provides

general information about SCF commands, and the reader should be familiar with that

information before reading the OSI/TS subsystem-specific information provided here.

Note that Table 2-1 does not describe commands supported by the X25AM or TLAM

(for D-series, or PAM subsystems for G06 and above releases). Such commands are

covered in the SCF reference manuals for those subsystems.