OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-25
ADD SU Command
X25DESTADDR
specifies the network address that is used as the called address in an outgoing call-
request packet. This attribute is used only for X.25 networks.
Value: A decimal string (0-9) up to 15 digits long.
Default: No default value is provided.
X25NEGOTIATE
specifies the network interface characteristics that are negotiable when a connection
is offered with unacceptable values for those characteristics. If X25AM receives a
call-request packet that contains an unacceptable value for L3WINDOW, PKTSIZE,
or THRUPUT and that characteristic has been defined as negotiable, it sends a call-
accept packet containing an acceptable value for that characteristic. If the
characteristic is not negotiable, X25AM clears the call request. This attribute is
used only for X.25 networks.
Use X25NEGOTIATE to set any value(s) to a negotiable state.
Value: L3WINDOW, PKTSIZE, THRUPUT
Specify one, two, or all three values.
Default: Defaults to the #L3 SERVICE X25NEGOTIATE value.
X25NONEGOTIATE
specifies the network interface characteristics that are not negotiable when a
connection is offered with unacceptable values for those characteristics. This
attribute is used only for X.25 networks.
Use X25NONEGOTIATE to set any value(s) to a nonnegotiable state.
Value: L3WINDOW, PKTSIZE, THRUPUT
Specify one, two, or all three values.
Default: Defaults to the #L3 SERVICE X25NONEGOTIATE value.
X25PORT
specifies the logical port number to be used by the subdevice. This attribute is used
only for X.25 networks.
Value: 0 through 9999
Default: 0
X25PRICALL
enables or disables the capability of making priority calls. This attribute is used
only for the DATAPAC network; it must be OFF if the network is other than
DATAPAC. This attribute is used only for X.25 networks.