OSI/TS SCF Reference Manual

OSI/TS SCF Commands

OSI/TS SCF Reference Manual—424832-001

2-26

ADD SU Command

Value: ON | OFF

Default: OFF

X25PVC

specifies the channel number of the permanent virtual circuit (PVC) with which the

X25AM subdevice to be created is bound. This attribute is used only for X.25

networks.

If a TSP subdevice is configured to use X25PVC, all other subdevices with the same

X25PVC must use transport class 2, 3 or 4. They will be multiplexed to use the

same X25PVC and no additional X25AM subdevices are created for either connect

or attach requests. The MULTIPLEX attribute will be ignored. If the transport class

used is 0 or 1 (non-multiplexing classes), then the subdevices must be configured

with different X25PVCs.

The value of X25PVC must be compatible with the values of the attributes

PVCRANGE and SVCRANGE (see the ALTER LINE command in the X25AM

product). Refer to the SCF Reference Manual for X25AM for information about

how to set up an X.25 line as a PVC line.

Value: 1 through 4095 for non-TRANSPAC networks

0 through 4095 for TRANSPAC networks

Default: Defaults to the #L3 X25PVC value.

X25REMOTENET

specifies the addressing conventions to be used when building the called address in

a call-request packet. This attribute is used only for X.25 networks.

TRANSPAC | TYMNET | UNINET | X25NP | X25SA | X25UD | X25XA

Default: Defaults to the #L3 SERVICE X25REMOTENET value.

X25REVERSECHG

specifies whether an outgoing call request asks the recipient to pay the charges. ON

indicates that the recipient is requested to pay the charges. OFF indicates that the

recipient is not requested to pay the charges. This attribute is used only for X.25

networks.

Value: ON | OFF

Default: OFF

X25RPOA

specifies the Recognized Private Operating Agency (RPOA) transit network(s) in

the facility field of a call-request packet. This attribute is used only for X.25

networks.