OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-27
Considerations for the ADD Command
Value: 0 through 9999
An RPOA transit network is indicated by the Data Network Identification Code
(DNIC), which is an integer with the range 0 through 9999. There can be 0 through
7 DNIC's in the X25RPOA integer list. If 2 through 7 integers are included in the
list, they must be enclosed in “()” and separated by blanks or commas.
Default: Defaults to the #L3 SERVICE X25RPOA value.
X25THRUPUT
specifies the throughput class limit for calls received (data transmission from the
called DTE) (integer1) and the throughput class limit for calls initiated (data
transmission from the calling DTE) (integer2). This attribute is used only for X.25
networks.
Value: 3 through 12 (for both integer1 and integer2)
Default: Defaults to the #L3 SERVICE X25THRUPUT value.
Note that these values are based on the CCITT X.25 recommendations for 1980 and
1984.
X25TRANSITDELAY
specifies the transit delay in the facility field of a call-request packet. This attribute
is used only for X.25 networks.
Value: 0.000 through 65.530 (0 through 65.53 seconds)
Default: Defaults to the #L3 SERVICE X25TRANSITDELAY value.
Considerations for the ADD Command
The considerations contain information about command use that should be read before
studying the command syntax in too much detail.
Value Bits per Second
375
4 150
5 300
6 600
7 1200
8 2400
9 4800
10 9600
11 19200