OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-29
Considerations for the ADD Command
If the network is 1984, set the #L3 SERVICE attribute IPX25SNDCF1980ADDR to
OFF before starting the TSP process.
Table 2-4. OSI/TS Protocol Selection for X.25 Wide Area Network
Attribute X.25 Network
X.25 Network
with SNDCF and Full IP
NSPDEVICE Specifies an X.25 line Specifies an X.25 line
CLASS 0-4 4
X25DESTADDR 1) Ignored for incoming
calls
2) Required for outgoing
calls
1) Ignored for incoming calls
2) Required for outgoing calls
IPX25SNDCF OFF ON
IPNULLLAYER Ignored Ignored
ESISENABLE Ignored Ignored
LOCALNSAP 1) Optional for 1984 X.25
2) Do not configure this
attribute for 1980 X.25
Required for both 1984 and 1980
X.25
REMOTENSAP 1) Optional for incoming
calls
2) Do not configure this
attribute for 1980 X.25
1) Optional for incoming calls
2) Required for outgoing calls for
both 1984 and 1980
X.25
LANLOCALSNPA Ignored Ignored
LANREMOTESNPA Ignored Ignored