OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-30
Considerations for the ADD Command
*In this case, specify the local or remote NSAP value in the SNPA format
(“FEmacaddress”). For a full explanation of the SNPA value, see the descriptions of the
SNPA attributes.
**Not providing a value, enables the ES-IS protocol to obtain the LAN remote SNPA
dynamically.
***These values are optional for the OSI/TS C30 release. They are required for earlier
product versions.
Table 2-5. OSI/TS Protocol Selection for Local Area Networks
Attribute
Full IP with
ES-IS Full IP, no ES-IS Null IP
NSPDEVICE Specifies a
TLAM line.
(Use PAM for
G06 and above
releases).
Specifies a TLAM
line. (Use PAM for
G06 and above
releases)
Specifies a TLAM
line.(Use PAM for
G06 and above
releases)
CLASS 4 4 4
X25DESTADDR Ignored Ignored Ignored
IPX25SNDCF Ignored Ignored Ignored
IPNULLLAYER Ignored OFF ON
ESISENABLE ON OFF OFF
LOCALNSAP Required Required Required*
REMOTENSAP 1) Optional for
incoming calls
2) Required for
outgoing calls
1) Optional for
incoming calls
2) Required for
outgoing calls
1) Optional for
incoming calls*
2) Required for
outgoing calls*
LANLOCALSNPA Optional*** Optional*** Required*
LANREMOTESNPA 1) Optional for
incoming calls
2) Optional for
outgoing calls;
should be
left unspecified
**
1) Optional for
incoming calls
2) Required for
outgoing calls
1) Optional for
incoming calls*
2) Required for
outgoing calls*