OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-32
Examples of the AGGREGATE Command
Examples of the AGGREGATE Command
The examples are designed to show correct ways of specifying command syntax.
PROCESS Object
AGGREGATE PROCESS $TP4
ALLOWOPENS Command
Use the ALLOWOPENS command to permit file-system opens to be issued to a
subdevice. This command reverses the effect of the STOPOPENS command.
This is a sensitive command.
The object-spec is:
Considerations for the ALLOWOPENS Command
The considerations contain information about command use that should be read before
studying the command syntax in too much detail.
SU Object
Use the STATUS command to determine whether a subdevice is subject to a
STOPOPENS command before issuing an ALLOWOPENS command. It would not
make sense to issue an ALLOWOPENS command on an SU unless a STOPOPENS
command is already pending.
Examples of the ALLOWOPENS Command
The examples are designed to show correct ways of specifying command syntax.
SU Object
ALLOWOPENS SU $TP4.#S10
ALLOWOPENS SU $TP4.*
ALTER Command
Use the ALTER command to change the values of the attributes of an existing object.
The ALTER command changes only the specified attributes of the target object.
ALLOWOPENS [ /OUT file-spec/ ] [ object-spec ]
object-type object-name
SU su-name