OSI/TS SCF Reference Manual

OSI/TS SCF Commands

OSI/TS SCF Reference Manual—424832-001

2-37

ALTER SERVICE #L3 Command

Default: OFF

ESISENABLE

enables and disables the ES-IS protocol.

Value: ON | OFF

Default: ON

ESISESCONFTIME

specifies the interval at which the protocol reports its configuration to the

subnetwork. This attribute is valid only when ESISENABLE is ON.

Value: 1.000 through 655.000 (1 through 655 seconds)

Default: 60.000 (60 seconds)

ESISESGROUPMACADDR

specifies the station group MAC address that all OSI end systems listen to. This

attribute is valid only when ESISENABLE is ON.

Altering this attribute is normally unnecessary, but where required, the new value

must be consistent with the value configured with the OSI routers (in the

intermediate system).

RESET returns this attribute to the default value.

Value: A hexadecimal string (0-9 and A-F) up to 12 digits long.

Default: 09002B000004

ESISHOLDTIME

specifies the interval for which the configuration information sent out by OSI/TS

should be held by the receiver of the information. This attribute is valid only when

ESISENABLE is ON.