OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-43
ALTER SERVICE #L3 Command
X25NONEGOTIATE
specifies the network interface characteristics that are not negotiable when a
connection is offered with unacceptable values for those characteristics. This
attribute is used only for X.25 networks.
Use X25NONEGOTIATE to set any value(s) to a nonnegotiable state.
Value: L3WINDOW, PKTSIZE, THRUPUT
Specify one, two, or all three values.
Default: Defaults to the value of the NONEGOTIATE attribute in X25AM.
X25PORT
specifies the logical port number to be used by the subdevice. This attribute is used
only for X.25 networks.
Value: 0 through 9999
Default: 0
X25PRICALL
enables or disables the capability of making priority calls. This attribute is used
only for the DATAPAC network; it must be OFF if the network is other than
DATAPAC. This attribute is used only for X.25 networks.
Value: ON | OFF
Default: OFF
X25PVC
specifies the channel number of the permanent virtual circuit (PVC) with which the
X25AM subdevice to be created is bound. This attribute is used only for X.25
networks.
If a TSP subdevice is configured to use X25PVC, all other subdevices with the same
X25PVC must use transport class 2, 3 or 4. They will be multiplexed to use the
same X25PVC and no additional X25AM subdevices are created for either connect
or attach requests. The MULTIPLEX attribute will be ignored. If the transport class
used is 0 or 1 (non-multiplexing classes), then the subdevices must be configured
with different X25PVCs.
The value of X25PVC must be compatible with the values of the attributes
PVCRANGE and SVCRANGE (see the ALTER LINE command in the X25AM
product). Refer to the SCF Reference Manual for X25AM for information about
how to set up an X.25 line as a PVC line.
RESET returns this attribute to the value of the PVC attribute in X25AM.
Value: 1 through 4095 for non-TRANSPAC networks 0 through 4095 for
TRANSPAC networks