OSI/TS SCF Reference Manual

OSI/TS SCF Commands

OSI/TS SCF Reference Manual—424832-001

2-44

ALTER SERVICE #L3 Command

Default: Defaults to the value of the PVC attribute in X25AM.

X25REMOTENET

specifies the addressing conventions to be used when building the called address in

a call-request packet. This attribute is used only for X.25 networks.

TRANSPAC | TYMNET | UNINET | X25NP | X25SA | X25UD | X25XA

Default: Defaults to the value of the NETID attribute in X25AM.

X25RPOA

specifies the Recognized Private Operating Agency (RPOA) transit network(s) in

the facility field of a call-request packet. This attribute is used only for X.25

networks.

RESET returns this attribute to the value of the RPOA attribute in X25AM.

Value: 0 through 9999

An RPOA transit network is indicated by the Data Network Identification Code

(DNIC), which is an integer with the range 0 through 9999. There can be 0 through

7 DNIC's in the X25RPOA integer list. If 2 through 7 integers are included in the

list, they must be enclosed in “()” and separated by blanks or commas.

Default: Defaults to the value of the RPOA attribute in X25AM.

X25REVERSECHG

specifies whether an outgoing call request asks the recipient to pay the charges. ON

indicates that the recipient is requested to pay the charges. OFF indicates that the

recipient is not requested to pay the charges. This attribute is used only for X.25

networks.

Value: ON | OFF

Default: OFF

X25THRUPUT

specifies the throughput class limit for calls received (data transmission from the

called DTE) (integer1) and the throughput class limit for calls initiated (data

transmission from the calling DTE) (integer2). This attribute is used only for X.25

networks.

Value: 3 through 12 (for both integer1 and integer2)