OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-50
ALTER SERVICE #L4 Command
MAXREXMIT
specifies the number of times unacknowledged TPDUs are retransmitted. This
attribute is valid only when the transport protocol class is 4.
Value: 1 through 8
Default: 3
MULTIPLEX
specifies whether more than one outgoing transport connection is mapped to one
network connection (ON) or not (OFF). To be able to multiplex, two or more
subdevices must have MULTIPLEX ON and have the same local NSAP and remote
NSAP (for outgoing connection requests). If these conditions are met, the
maximum number of outgoing transport connections that are multiplexed together is
determined by the value of the X25NCONMULTIPLEX attribute (see the ALTER
SERVICE #L3 command). See the considerations for the ALTER command for a
discussion of the relationship between the ALTCLASS, CLASS, MULTIPLEX, and
NETTYPE attributes. This attribute is used only for outgoing connections on X.25
networks.
Value: ON | OFF
Default: OFF
NETTYPE
specifies the quality of the network services. See the considerations for the ALTER
command for a discussion of the relationship between the ALTCLASS, CLASS,
MULTIPLEX, and NETTYPE attributes.
Value: A | B | C
Default: A If the CLASS attribute is specified, its value overrides the value of
NETTYPE.
Type
Quality of Network
Service
A Acceptable rates of
unsignaled and signaled
errors
B Acceptable rate of
unsignaled errors but
unacceptable rate of
signaled errors
C Unacceptable rate of
unsignaled errors