OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-51
ALTER SERVICE #L4 Command
OUTBOUNDCRCONFERRTHLD
is the threshold value that the Transport Layer compares to the counter
OUTBOUNDCRCONFERR. OUTBOUNDCRCONFERR is the number of times
the subsystem receives a DR-TPDU refusing a connection request due to negotiation
failure, duplicate source reference, mismatched references, reference overflow,
refused on the network connection, session entity not attached to TSAP, or address
unknown.
Value: 0 through 65535
If the threshold is 0, threshold events are never generated for this counter.
Default: 0
OUTBOUNDCRERRTHLD
is the threshold value that the Transport Layer compares to the counter
OUTBOUNDCRERR. OUTBOUNDCRERR is the number of times the subsystem
timed out waiting for a response to a CR-TPDU or receives a DR-TPDU refusing a
connection request due to protocol error, invalid header or parameter not specified,
or reason not specified.
Value: 0 through 65535
If the threshold is 0, threshold events are never generated for this counter.
Default: 0
OUTBOUNDTPDUPROTOERRTHLD
is the threshold value that the Transport Layer compares to the counter
OUTBOUNDTPDUPROTOERR. OUTBOUNDTPDUPROTOERR is the number
of times the subsystem receives a DR-TPDU or ER-TPDU as the response to any
TPDU it initiated other than the CR-TPDU.
Value: 0 through 65535
If the threshold is 0, threshold events are never generated for this counter.
Default: 0
PASSIVEMUX
specifies the sharing of X25AM SUs for attaching TSP SUs in anticipation of
multiplexing performed by the remote transport entity (incoming connections). If
this attribute is ON, the TSP process will assume that the remote transport entity
will multiplex all transport connections destined to the same X.25 port (same DTE
address). In this situation, the TSP process will not attempt to create an X25AM SU
for each transport attach request. This will greatly reduce the number of X25AM
SUs created at the time attach requests are made. Note, that the assumption is based
solely on the X.25 port number and not the local TSEL.
Value: ON | OFF