OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-52
ALTER SERVICE #L4 Command
Default: OFF
RECVSECURITY
specifies whether security checking is performed on incoming CR-TPDUs. If
security checking is specified, only incoming CR-TPDUs that have matching
characters in the protection field are accepted. If a value is not provided, no security
checking is performed. This attribute is valid only when the transport protocol class
is 1, 2, 3, or 4.
Note that not all transport protocol implementations support this attribute.
RESET returns this attribute to the default value (no security checking specified).
Value: An ASCII string up to 16 characters long.
Default: No default value is provided.
REFTIMEOUT
specifies the amount of time before which no reference or sequence numbers are
reused.
Value: 3.000 through 180.000 (3 through 180 seconds)
Default: 30.000 (30 seconds)
REXMITTIMEOUT
specifies the amount of time before which an unacknowledged TPDU is
retransmitted. This attribute is valid only when the transport protocol class is 4.
Value: 1.000 through 30.000 (1 through 30 seconds)
Default: 10.000 (10 seconds)
SENDSECURITY
specifies the content of the protection field for CR-TPDUs and CC-TPDUs. If a
value is not provided, the protection field is omitted. This attribute is valid only
when the transport protocol class is 1, 2, 3, or 4.
Note that not all transport protocol implementations support this attribute.
RESET returns this attribute to the default value (no protection field specified).
Value: An ASCII string up to 16 characters long.
Default: No default value is provided.
TCONPRI
specifies the priority of the transport connection. This attribute is used to reassign
transport connections after errors have occurred.