OSI/TS SCF Reference Manual

OSI/TS SCF Commands
OSI/TS SCF Reference Manual—424832-001
2-55
ALTER SU Command
ALTCLASS
specifies the protocol class to be used as an alternative to the preferred protocol
class. See the considerations for the ALTER command for a discussion of the
relationship between the ALTCLASS, CLASS, MULTIPLEX, and NETTYPE
attributes.
Value: 0 | 1 | 2 | 3 | 4
Default: None
CHECKSUM
specifies whether checksum fields are added to TPDUs. This attribute is valid only
when the transport protocol class is 4.
Value: ON | OFF
CLASS
specifies the preferred transport protocol class. See the considerations for the
ALTER command for a discussion of the relationship between the ALTCLASS,
CLASS, MULTIPLEX, and NETTYPE attributes.
For LAN networks, the transport protocol class must be 4.
For X.25 networks, when IPX25SNDCF is OFF, the transport protocol class can be
0, 1, 2, 3, or 4.
For X.25 networks, when IPX25SNDCF is ON, the transport protocol class must be
4.
Value: 0 | 1 | 2 | 3 | 4
[ X25ACCEPTCHG { ON | OFF } ]
[ X25BCUG integer | RESET ]
[ X25CUG { integer | RESET } ]
[ X25CUGTYPE { BASIC | EXT | BASICOA | EXTOA } ]
[ X25DESTADDR { "address" | RESET } ]
[ X25NEGOTIATE { value | "(" value [, value ] ...")" } ]
[ X25NONEGOTIATE { value | "(" value [, value ] ...")" } ]
[ X25PORT integer ]
[ X25PRICALL { ON | OFF } ]
[ X25PVC { integer | RESET } ]
[ X25REMOTENET { DATANET | DATAPAC | DATEXP | DDXP | PSS |
TELENET | TRANSPAC | TYMNET | UNINET |
X25NP | X25SA | X25UD | X25XA } ]
[ X25RPOA
{ integer | "(" integer [ , integer ] ...")" | RESET } ]
[ X25REVERSECHG { ON | OFF } ]
[ X25THRUPUT "(" integer1, integer2 ")" ]
[ X25TRANSITDELAY integer | RESET ]