OSM Service Connection User's Guide (G06.30+)

Abort Primary Path
Terminates operation of the primary path to the disk. When the Abort action finishes, the path is in
the Stopped state.
BLINK LED Off
Stops the blinking of the fault LED initiated by the Blink LED On action.
BLINK LED On
Causes the fault LED to blink to make it easier to identify the component.
Clear Data
Erases all data on the disk but leaves the disk label intact. Clear Data does not erase the FIR data in
the CE sector, the volume label, the boot sector, or the spare tracks table. After a Clear Data action
completes or is cancelled, the disk drive is not usable until you restore the file system by using the
SCF Alter Label command.
Firmware Update
Updates disk drive firmware.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary if the disk was
in a STOPPED state, substate HARDDOWN; a hardware error has occurred; the disk was stopped
with an ABORT command; or a STOP or ABORT fails to put the disk into the STOPPED state,
substate DOWN.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Start Backup Path