OSM Service Connection User's Guide (G06.30+)

Grasp the FCSA by its ejector in one hand and slowly pull the FCSA part way out of the slot.6.

Grasp the FCSA by its handle while supporting the bottom edge of the FCSA with the other

hand and pull the FCSA the rest of the way out of the slot.

Note: The FCSA weighs approximately 7.25 pounds (3 kilograms).

Place the FCSA on the antistatic mat.8.

Installing the Replacement FCSA

Note: Whenever you handle a FCSA, follow standard operating practices to avoid damage to the

equipment. Review the standard operating practices documented in the Fibre Channel

ServerNet Adapter Installation and Support Guide.

Unpack and inspect the FCSA:

Put on an ESD wrist strap and attach the grounding clip to the antistatic mat.a.

Place the package containing the FCSA on the antistatic mat.b.

Open the packing container and remove the FCSA.

Caution: When opening the packing container, be careful not to cut into the ESD

protective bag.

Visually inspect the FCSA and the backplane connector for damage. Use a flashlight, if

necessary, to check for bent or broken pins. If the FCSA is damaged or has a damaged

connector-pin socket, do not install it.

Caution: If you insert a FCSA that has a damaged socket into a slot, that FCSA's

backplane pins and the connectors on other adapter boards also inserted

into that slot can be damaged. Moving a damaged adapter from slot to slot

can damage other slots and other adapters.

Disconnect the grounding clip of your ESD wrist strap from the antistatic mat, and then

connect it to an unpainted metal surface on the FCSA.

Caution: Do not attach the ESD grounding clip to doors or to any painted surface.

Carry the FCSA to the enclosure:

Grasp the FCSA by its handle in one hand, while supporting the bottom edge of the

FCSA with the other hand.

Note: The FCSA weighs approximately 7.25 pounds (3 kilograms).

Carry the FCSA to the back of the IOAM enclosure.b.

Set the FCSA down on an antistatic mat right side up with the ejector at the top.c.

Disconnect the grounding clip of your ESD wrist strap from the FCSA and connect it to any

unpainted metal surface on the IOAM enclosure or on the rack in which the enclosure is