OSM Service Connection User's Guide (G06.30+)

UPS
Attributes
Actions
Uninterruptible power supply (UPS) unit that provides backup power for IOAM enclosures.
Note: OSM supports SNMP card versions up to and including v3.20.
Location in OSM Tree: System > Monitored Service LAN Devices > UPS
Example: UPS SDUPS
Attributes
UPS
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK. Values
Physical
Battery Status
Indicates the current status of the UPS battery. Possible values are
Normal and On Battery.
OSM displays a yellow alarm if the UPS goes On Battery (or starts
drawing power from the battery). This alarm goes away when the UPS
stops drawing power from the battery. OSM displays a red alarm when
the battery power is low.
Device Status Indicates whether the UPS is up or down.
Firmware Version Version of the firmware on the UPS SNMP card.
Identificaton Information
Displays additional information about the UPS as set by super-user in the
web interface (see the Link to Web Interface action). Up to 20 characters
are allowed.
Example: UPS Web Card
IP Address The IP address of the UPS.
Serial Number
The unique number assigned to the UPS in manufacturing. Knowing the
serial number is especially helpful when you need to replace batteries or
required other service.
Example: TU321A1185
Software Version Displays the version of the UPS software.
Type
Displays the UPS model version.
Example: R5500 XR