OSM Service Connection User's Guide (G06.30+)

Chapter 3. Configuring OSM
Prev Next
Chapter 3. Configuring OSM
Configuring the Server
Defining Users
Configuring Service Provider Access
Dial-out/Dial-in
Unattended Site
Before using OSM applications to manage your system:
Configure the server using the OSM Low-Level Link.●
Configure service provider access using the OSM Notification Director.●
Configure the OSM Notification Director during OSM installation to run as a Windows
Service, which allows it to run without requiring a Windows logon. For more
information, see Installing OSM Components.
●
Note: It is possible to start and run a new server without performing OSM configuration.
However, HP strongly recommends that you perform OSM configuration tasks
shortly after installing a new system. If you do not perform OSM configuration, your
system will have certain user, security, and network limitations.
For complete configuration procedures, see:
NonStop NS-Series Hardware Installation Manual●
OSM Low-Level Link online help●
OSM Notification Director online help●
You can also (optionally) change many OSM default settings by creating and using an
OSMCONF file from the OSMINI template. For information on these configurable parameters
and how to make OSMCONF changes take effect, see the OSM Migration and Configuration
Guide.
Configuring the Server
Defining Users
You must configure these server components using the OSM Low-Level Link: