OSM Service Connection User's Guide (G06.30+)

Performing Firmware Updates

Performing a Firmware Update

To update down-rev firmware for a specific resource, use one of the actions available for that

resource.

Performing a Firmware Update

Select Display>Multi-Resource Actions.1.

From the Resource Type drop-down list, select the type of resource on which to perform

the firmware update. All resources of the selected type appear in the available resources

list.

From the Action drop-down menu, select the action to perform. A second resources list is

displayed below the first:

You can resize the panes by using the divider line above the add and remove

buttons.

●

You can sort either resources list by clicking the bottom line of the column

heading.

●

To further refine the resources on which to perform the firmware update, select a

parameter from the Filter by drop-down list. Only resources in the available resources list

with the specified characteristic are displayed.

Some actions, such as SP Firmware Updates should not be performed on all SPs

simultaneously. For these potentially disruptive actions, the Filter by menu forces you to

choose between X-fabric or Y-fabric SPs.

The Compare State - Down-rev parameter is shown only if any down-rev firmware

actually exists.

Select the specific resources on which to perform the action:

Select To

Add all

Move all resources in the available resources list to the selected resources

list. (The Add all button is enabled only when no resource in the available

resource list is highlighted.)

Add

Move a specific resource (selected by clicking it) from the available list to

the selected list.

Remove all Move all resources from the selected list back to the available list.

Remove

Move a specific resource (selected by clicking it) from the selected list back

to the available list.