OSM Service Connection User's Guide (G06.30+)

Responsive Test
Verifies that the component is connected and responding.
Start
Starts the ATM CRU and the associated ATM line. The ATM CRU must be in the Stopped state
before you perform this action.
During startup, the controller operational code is automatically loaded into the ATM CRU. When the
Start action finishes, the ATM CRU and the ATM line are in the Started state.
Test Verify
Runs all the firmware diagnostic tests on the CRU. This test takes about three minutes to finish. The
CRU must be in the Stopped state before you initiate the Test Verify action.
ATM Line
Attributes
Actions
The Asynchronous Transfer Mode (ATM) line represents the logical link between the ATM CRU
and the ATM network. There is one ATM line per ATM CRU.
Location in OSM Tree: System > Group > Module > ATM3SA > Line
Example: Line $ATM (1.1.54)
Attributes
Line $ATM
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK. Values
Logical
Maximum Number of VPCs
The maximum number of virtual path connections (VPCs).
Value: 0 through 256
Maximum Number of VCCs
The maximum number of virtual channel connections (VCCs).
Value: 0 through 3072
ATM Address Configured The address that is specified for this ATM Line.