OSM Service Connection User's Guide (G06.30+)

Enable Drive Bypass
Shuts down the specified port or ports (A and/or B) on the disk drive.
Firmware Update
Updates firmware for the Fibre Channel disk drive. This action can be performed only when both
Primary and Backup paths are in the Down state.
Replace
Displays the procedure for replacing the disk.
Reset Backup Path
Places the backup path in a state from which it can be started.
Reset Disk
Places the disk in a state from which it can be started. This action might be necessary before starting
a disk that has both paths in a Hard Down state; for example, if a hardware error has occurred, if the
disk was stopped with an Abort action, or if a Stop or Abort fails to put the disk into the Down state.
If only one disk path is in a Hard Down state, you can use the Reset Primary Path or Reset Backup
Path as appropriate.
Reset Primary Path
Places the primary path in a state from which it can be started.
Reset Volume
Places the volume in a state from which it can be started.
Responsive Test
Verifies that the disk drive is installed and responding.
Spin Down
Stops the physical spinning of the disk drive. This should be done before removing a disk drive. Both
paths must be down for the action to succeed.
Spin Up
Starts the physical spinning of the disk drive.
Start Backup Path
Starts the backup path to this disk drive. When the Start action completes, the backup path is in the