OSM User's Guide (G06.27+)
Table Of Contents
- OSM User's Guide
- OSM User's Guide
- What's New in This Guide
- About This Guide
- Related Reading
- Chapter 1. Introducing OSM
- Chapter 2. Preparing the OSM Environment
- Chapter 3. Configuring OSM
- Chapter 4. Starting the OSM Service Connection
- Chapter 5. Using the Management Window
- Chapter 6. Viewing Alarms
- Chapter 7. Viewing Attributes
- Chapter 8. Performing Actions
- Chapter 9. Viewing Summary Reports
- Chapter 10. Managing a System
- Chapter 11. System Resources
- Chapter 12. Managing a ServerNet Cluster
- Chapter 13. Cluster Resources
- Chapter 14. Updating ServerNet Cluster Topology
- Glossary
- Index
- Legal Notice
- Version and Copyright Information
If the group is an enclosure on the inner tetrahedral ring, there are no enclosures off this
enclosure.
●
There are no IOMF enclosures off this enclosure.●
If the checks complete successfully, or you choose to disregard any warnings and proceed, the action
allows you to disable the batteries and halt the processors.
After these operations complete successfully (or you choose to disregard any warnings), you can
complete the action and power off the group.
Set Service LED State
Turns the service light-emitting diode (LED) on or off for this group. Use this action to mark an
enclosure to make it easily locatable for service.
Parameter: Service LED State
on: turns LED on
off: turns LED off
Group (IOAM)
Attributes
Actions
An IOAM Group is a logical entity that represents a physical I/O Adapter Module enclosure.
Attributes
Group
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK. Values
Actions
Rediscover
Causes OSM to refresh and reanalyze the group and all subcomponents. Refresh refers to OSM
updating the attribute values displayed in the OSM Service Connection interface. Reanalyze refers to
the running of OSM incident analysis, which checks EMS event messages and creates alarms in
OSM if certain conditions exist.