OSM User's Guide (G06.27+)
Table Of Contents
- OSM User's Guide
- OSM User's Guide
- What's New in This Guide
- About This Guide
- Related Reading
- Chapter 1. Introducing OSM
- Chapter 2. Preparing the OSM Environment
- Chapter 3. Configuring OSM
- Chapter 4. Starting the OSM Service Connection
- Chapter 5. Using the Management Window
- Chapter 6. Viewing Alarms
- Chapter 7. Viewing Attributes
- Chapter 8. Performing Actions
- Chapter 9. Viewing Summary Reports
- Chapter 10. Managing a System
- Chapter 11. System Resources
- Chapter 12. Managing a ServerNet Cluster
- Chapter 13. Cluster Resources
- Chapter 14. Updating ServerNet Cluster Topology
- Glossary
- Index
- Legal Notice
- Version and Copyright Information
Power cycles the ServerNet Switch Board.
Replace
Launches the guided procedure to replace a ServerNet switch board in an IOAM or processor switch.
Set LED State
Turns the ServerNet Switch Board LED on or off.
Soft Reset
Reinitializes the firmware without affecting the ServerNet Switch Board hardware or the routing
tables.
Service Processor (SP)
Attributes
Actions
The service processor (SP) controls environmental and maintenance functions and acts as the master
of the serial maintenance bus (SMB). The service processor is a physical component of PMF, PMF2,
IOMF, and IOMF2) CRUs.
Location in OSM Tree: System > Group > Module > PMF2 > SP
Slot Location: Service processors are located on the PMF CRUs and IOMF CRUs in slots 50 and 55
of processor and I/O enclosures (service side).
Example: SP (1.1.50)
Attributes
SP
Service State
Displayed in the Attributes tab and Attributes dialog box only if the value is
something other than OK. Values
Physical
Time of Last Reset The date and time that the service processor was last reset.
Stored Topology
The maximum processor configuration for the service processor that is set
the next time the system or enclosure is powered on. Values