OVNPM 1.5.2 - Performance Agent for NonStop Display Agent Guide

Using SystemAlert 123
9-6 Activating Thresholds
A threshold can be active or inactive, as follows:
Threshold Status Description
Active SystemAlert monitors this threshold
Inactive SystemAlert does not monitor this threshold
Threshold groups only take into account thresholds that are active. If any threshold in a group is active, then the
group is automatically active.
When a threshold is active, a threshold alarm can be in a normal or an alert state.
Alarm State Description
Normal Threshold condition has not occurred
Alert SystemAlert detected that the threshold condition has occurred
Use the following steps to activate one or more thresholds.
1. Open the Groups and Thresholds Configuration dialog box and click on the Thresholds tab to access the
corresponding tab page.
2. Select one or more thresholds from the Threshold list box.
3. Select the ON check box. The word ON appears next to the name in the Threshold list.
To deactivate a threshold, clear the ON check box.
Using SystemAlert