OVNPM 1.5.2 - Performance Agent for NonStop Display Agent Guide

Using Views: SystemInsight 62
6-4 Selecting Units
After you open a view, there are two possible results:
• If units are already assigned to the view’s metrics, the view displays data. If the view is generic and there is
only one unit in the domain, the view displays data for the single unit.
• If the view is generic and there is more than one unit, the Unit Selection dialog box opens. You must select
units before displaying the view.
6-4-1 Temporarily Assigning Units to a Generic View
Generic views do not have assigned units. Each time you open a generic view, you must temporarily assign
units.
1. Open a generic view. The Unit Selection dialog box opens.
Figure 6-3 Unit Selection Dialog Box
2. Select a metric from the Selected Metrics list box. A list of available units for the selected metric appears in
the Units box.
3. Select a unit from the Units box. The unit name is added to the metric.
4. To define a different unit to each metric, repeat Step 2 and Step 3. To define the same unit to all metrics,
click on the Set All button.
5. Click on the OK button. The view opens and displays data.
To clear the unit name for a single or several metrics at one time, select the metric(s) and click on the Reset
button. The unit name is no longer associated with the selected metrics.