PAM Configuration and Management Manual

PAM Configuration and Management Manual—523349-003
ix
About This Manual
This manual describes how to configure and operate the PAM subsystem on a
NonStop S-series server and on an Integrity NonStop NS-series server. It includes
detailed descriptions of the Subsystem Control Facility (SCF) commands used with the
PAM subsystem and a quick-reference section to the command syntax.
Who Should Use This Manual
This manual is intended for those who use the PAM subsystem on NonStop S-series
servers or on Integrity NonStop NS-series servers, or who are migrating from the port
interface of TLAM on HP NonStop K-series systems.
What’s in This Manual
Other Manuals
Depending on the tasks you are performing, you might also need these manuals:
•
6763 Common Communication ServerNet Adapter Installation and Support Guide
•
LAN Configuration and Management Manual
•
SCF Reference Manual for G-Series RVUs
•
SCF Reference Manual for H-Series RVUs
•
SCF Reference Manual for the Kernel Subsystem
•
Token-Ring Adapter Installation and Support Guide
Table i. Summary of Contents
Section Title This section. . .
1 Configuration Quick Start
Describes the initial configuration and startup of
the PAM subsystem.
2 Introduction
Describes the components of PAM.
3 SCF for PAM
Describes the SCF commands for the PAM
subsystem.
A TLAM to PAM Migration Guide
Compares the system components and
functions of the TLAM and PAM subsystems.
B SCF Command Summary
Provides a quick-reference guide to the syntax
of the SCF commands for the PAM subsystem.
C SCF Error Messages
Lists the SCF error messages for PAM.