PAM Configuration and Management Manual

SCF for PAM
PAM Configuration and Management Manual—523349-003
3-32
START Command
switch to the backup processor only if the backup processor has data-path access
to the associated LIF.
Example
This example switches the line’s primary processor to CPU 1:
-> PRIMARY LINE $PAMA, CPU 1
START Command
The START command is a sensitive command that initiates the operation of an object.
Successful completion of the START command leaves the object in either the
STARTED or STARTING summary state.
START LINE Command
The START LINE commands starts the specified LINE object and enables access to
the associated LIF.
Command Syntax
OUT file-spec
directs any SCF output generated for this command to the specified file.
LINE line-name
is the name of the line.
SUB [ ALL | NONE | ONLY ]
directs the command at a set of subordinate objects.
ONLY specifies that only the subordinate objects are affected.
ALL specifies that the named object and the subordinate objects are affected.
NONE specifies that none of the subordinate objects are affected.
SEL [NOT] state
directs the command only to objects in the specified state or only to those not in
the specified state. Valid states are STARTED, STARTING, STOPPED,
STOPPING, and SUSPENDED.
START [ /OUT file-spec/ ] LINE line-name
[ SUB , [ ALL | NONE | ONLY ] ] [ , SEL [ NOT ] state ]